|
JCapper Message Board JCapper 101
|
| Home |
Register
Log In |
| By | UPR | |
| tennoel 6/19/2012 7:23:45 PM | When operating in SQL mode, can you use factors in your UPR, such as pcte, that are not part of your 35 factor set? I'm setting up a base 1000 UPR, and want to use more factors than I currently have defined. Also, in using the base 1000 with a subtr 1 for each rank, I'm always under 100 points on the html report. Is this correct?
| |
| jeff 6/21/2012 2:26:52 PM | --quote: ""When operating in SQL mode, can you use factors in your UPR, such as pcte, that are not part of your 35 factor set? I'm setting up a base 1000 UPR, and want to use more factors than I currently have defined.""--end quote Yes. In both playlistfile mode and sql mode you can use the ImpactValues Tables Wizard Interface to "grab" any factor you want from the factors list - even if that factor isn't part of the sql factor setup. (The sql factor setup controls which factors get written to the starterhistory and starterstoday tables.) --quote: "Also, in using the base 1000 with a subtr 1 for each rank, I'm always under 100 points on the html report. Is this correct?"--end quote It's most likely correct - depending on the factors used (the factor mix) for the groupname. -jp .
|
| Reply |
|
Copyright © 2018 JCapper Software back to the JCapper Message Board www.JCapper.com |